Homers Driving School

Driving School & Driving Instructor Training

Show me how to check that the direction indicators are working.Applying the hazard warning switch and check functioning of all indicators.

Show me how to check that the brake lights are working on this car.Operate brake pedal, make use of reflections in windows, garage doors, etc, or ask someone to
help.

Show me how you would check that the power assisted steering is working before starting a journey. If the steering becomes heavy the system may not be working properly. Two simple checks can be made. Gentle pressure on the steering wheel, maintained while the engine is started, should result in a slight but noticeable movement as the system begins to operate. Alternatively turning the steering wheel just after
moving off will give an immediate indication that the power assistance is functioning.

Show me how you would check the parking brake for excessive wear, make sure you keep safe control of the vehicle Apply footbrake firmly. Demonstrate by applying parking brake so that when it is fully applied it secures itself, and is not at the end of the working travel.

Show Open the bonnet, identify where you would check the engine oil level and tell me how you would check that the engine has sufficient oil. Identify dipstick / oil level indicator, describe check of oil level against the minimum/maximum markers.

Show Open the bonnet, identify where you would check the engine coolant level and tell me how you would check that the engine has the correct level. Identify high/low level markings on header tank where fitted or radiator filler cap, and describe how to top up to correct level.

Show Open the bonnet, identify where the brake fluid reservoir is and tell me how you would check that you have a safe level of hydraulic brake fluid. Identify reservoir, check level against high/low markings.

Show me how you would check that the horn is working (off road only). Check is carried out by using control.

Show me how you would clean the windscreen using the windscreen washer and wipers Operate control to wash and wipe windscreen.

Show me how you would set the demister controls to clear all the windows effectively, this should include both front and rear screens Set all relevant controls including; fan, temperature, air direction and heated screen to clear windscreen.

Show me how you would switch on the rear fog light and explain when you would use it/them. Operate switch . Check warning light is on. Explain use.

Tell me how you would know if there was a problem with your anti lock braking system Warning light should illuminate if there is a fault with the anti lock braking system

Tell me how you would check that the headlights & tail lights are working. Explanation: Operate switch then walk round vehicle.

Show me how you switch your headlight from dipped to main beam and explain how you would know the main beam is on whilst inside the car Operate switch, check with main beam warning light

Tell me how you would check that the brakes are working before starting a journey.
Brakes should not feel spongy or slack. Brakes should be tested as you set off. Vehicle should not pull to one side.

Tell me. Identify where the windscreen washer reservoir is and tell me how you would check the windscreen washer level. Identify reservoir and explain how to check level.

Tell me where you would find the information for the recommended tyre pressures for this car and how tyre pressures should be checked. Manufacturer's guide, use a reliable pressure
gauge, check and adjust pressures when tyres are cold.

Tell me how you make sure your head restraint is correctly adjusted so it provides the best protection in the event of a crash. The head restraint should be adjusted so the rigid
part of the head restraint is at least as high as the eye or top of the ears, and as close to the back of the head as is comfortable

Tell me how you would check the tyres to ensure that they have sufficient tread depth and that their general condition is safe to use on the road. No cuts and bulges, 1.6mm of tread depth across the central breadth of the tyre and around the entire outer circumference.

Tell me how you would check that the headlights & tail lights are working. Explanation: Operate switch , then walk round vehicle.

Driving Instructor, Driving Instructor Training, Driving School, Driving Instructor, Driving Instructor Training, Driving School, Driving Instructor, Driving Instructor Training, Driving School, Driving Instructor, Driving Instructor Training, Driving School, Driving Instructor, Driving Instructor Training, Driving School, Driving Instructor, Driving Instructor Training, Driving School, Driving Instructor Training, Driving School,Driving Instructor Training, Driving School,